This is a record of a dentist’s journey to understand the fundamental principles of telephoto lenses. From focal length and image circles to angle of view, I stripped it all down to the basics.
I Thought Lenses Were Just Magnifying Glasses
As I started astrophotography, I began using telephoto lenses.
Naturally, a question arose: why does a longer focal length make objects look larger?
My initial assumption was simple:
“Light converges to a single point like a magnifying glass, flips upside down as it crosses over, and the sensor sits somewhere behind that point — right?”
Wrong. It took me an hour of debating with an AI to break this misconception.
The True Definition of Focal Length: Understanding via the Sun
If you hold a convex lens under sunlight, it burns a hole in paper. The distance from the lens to that burning spot is the focal length (f).
Because the Sun is so far away, its rays enter the lens almost perfectly parallel. Parallel rays converge into practically a single point — small enough to burn paper, though the Sun does occupy about 0.5° of angle in the sky. In a 500mm lens, this happens approximately 500mm behind the lens.
This is a fixed value determined at the factory.
Real-World Objects Do Not Converge to a Single Point
This is where I got stuck.
Unlike the Sun, light from everyday objects — reflective sources — behaves differently.
Light from Point A on an object → passes through the lens → lands on Position A’ on the sensor. Light from Point B on an object → passes through the lens → lands on Position B’ on the sensor.
Because light enters from various angles, it forms a plane at the image distance, not a single point.
A lens is not a device that gathers light into a point.
A lens maps incoming ray angles to positions on an image plane.
This one sentence broke my misconception completely.
Where is the Sensor? — Warning: Never Aim at the Sun
The sensor is placed on the image plane — the plane where a sharp image forms.
For a subject at infinity (like the Sun or distant stars), that plane sits exactly at the focal length f. For closer subjects, the image plane shifts further back, following the thin lens equation:f1=do1+di1
do: distance to the subject. di: distance to the image plane (where the sensor sits).
This is why macro lenses extend outward when focusing up close — the sensor needs to move further from the lens to stay on the image plane.
I also realized something here on my own:
“If I aim a camera at the Sun, the sensor will melt.”
This is a real danger. In the film era, sunlight burned holes in shutters. Today, it permanently destroys pixels. The risk increases when the focal length is long and the aperture is wide — specifically, when the f-number (f/D) is small, energy density on the sensor is highest. A longer focal length with the same aperture diameter concentrates more energy and is more dangerous. But two lenses with the same f-number carry similar risk, regardless of focal length.
[Image comparing direct sunlight vs. reflected light paths through a camera lens]
The Image Circle: A Fixed Property of the Lens
I used to think the image circle changed based on the subject.
Wrong again.
The image circle — the maximum area a lens can project — is a fixed value determined by the lens design. Whether you photograph a mountain or a marble, the circle stays the same. What changes is what fits inside that circle.
This is why Full-Frame and APS-C lenses exist separately. When the sensor is larger than the image circle, the edges go dark. That is called vignetting.
Finally — Why Long Focal Lengths Narrow the View and Magnify
Now the core physics.x=f⋅tan(θ)
x: Distance from the sensor center to where the light lands. f: Focal length. θ: The angle of the incoming light.
Light entering along the optical axis lands at the center of the sensor. Light entering at an angle lands away from the center — the greater the angle, the further from center it lands.
When f increases, the same angle θ is projected further from the sensor center.
But the sensor size is fixed.
So the maximum angle that can fit onto the sensor gets smaller. This is why the angle of view narrows.
And that narrow slice of the world is now stretched across the entire sensor. This is why the subject appears magnified.
Magnification is not caused by “zooming in.” It is caused by the fact that the same angular information is projected over a larger distance (f), while the sensor size remains fixed.
In one sentence:
A telephoto lens does not magnify objects. It enlarges angular information onto a fixed sensor.
Summary
| Concept | Core Truth |
|---|---|
| Focal Length | Distance where parallel rays converge. A fixed lens property. |
| Sensor Position | Always at the image plane — which equals f only for subjects at infinity. |
| Real-World Subject | Does not form a point. Forms an image on a plane. |
| Image Circle | Fixed by lens design. Independent of the subject. |
| Magnification Principle | Narrower angles projected across the same sensor area. |
One thing you can do today. Take a magnifying glass outside and find the point where sunlight burns the tightest spot on paper. That distance is the focal length. Physics is best understood through the fingertips.
Giving you the Universe,
답글 남기기